Author Topic: Walther RM 8 woes  (Read 501 times)

0 Members and 1 Guest are viewing this topic.

Offline Baggawind

  • Hero Member
  • *****
  • Posts: 1634
  • Karma: +1189/-4
  • Planet Airgun's Pied Piper
Walther RM 8 woes
« on: August 28, 2019, 11:34:42 AM »
Just a word of warning to anyone out there who owns one of these. Like all pneumatics, the seals will eventually need replacing. I recently re-sealed the reg in my mates rifle , simple enough task one would think. But no . Assuming you put the Belville washers back in the correct order you might get lucky and have the rifle performing as it was pre- leaking. If not , it will need adjusting. Trouble is . no one makes a reg tester for these rifles. And, worse still, the firing valve is part of the reg and is sealed not with an O ring but thread sealant. Assuming you can remove the firing valve , you,ll still have to have a reg tester made. So, my advice is , if you have a leaking reg get it replaced as a complete unit.